Installation; Points To Be Paid Attention To When The Relocation Of The Appliance; Before You Start The Appliance - Blomberg SSM4450 User Manual

3

Installation

B
The manufacturer will not be liable
for any event caused by disregarding
the information supplied in this user
manual.
Points to be paid attention
to when the relocation of the
appliance
1. Your appliance should be unplugged.
Before transportation of your
appliance, it should be emptied and
cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside
your appliance should be fixed with
adhesive tape and secured against
impacts. Packaging should be
adequate and the transportation rules
on the package should be strictly
observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the
appliance,
Check the following before you start
to use your appliance:
1. Clean the interior of the appliance as
recommended in the "Maintenance
and cleaning" section.
2. Connect the plug of the appliance to
the wall socket. When the fridge door
is opened, fridge internal lamp will
turn on.
3. When the compressor starts to
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is
not running and this is quite normal.
4. Front edges of the appliance may feel
warm. This is normal. These areas
are designed to be warm to avoid
condensation.
• Condenser of your refrigerator is on
the rear side. In order to increase
the energy efficiency by minimizing
the power consumption, the upper
part of the condenser on the rear
side of the product must be pulled
backwards and locked as shown in
the figure. When the condenser is
pulled back, the right and left upper
holders are locked and the position of
the condenser is fixed.
13
EN