Alternate Macro - ABB ACS150 User Manual

Alternate macro

This macro provides an I/O configuration adapted to a sequence of DI control
signals used when alternating the rotation direction of the drive. To enable the
macro, set the value of parameter
For the parameter default values, see section
on page 63. If you use other than the default connections presented below, see
section
Default I/O connections
1)
See parameter group
DI3 DI4 Operation (parameter)
0
1
0
1
I/O terminals on page 32.
X1A
1 SCR
2 AI
3 GND
3)
4 +24V
5 GND
6 DCOM
7 DI1
8 DI2
9 DI3
10 DI4
11 DI5
X1B
12 COM
13 NC
14 NO
12 CONSTANT
0 Set speed through
integrated potentiometer
0 Speed 1 (1202)
1 Speed 2 (1203)
1 Speed 3 (1204)
9902 to 3 (ALTERNATE).
Default values with different macros
Signal cable shield (screen)
Frequency reference: 0...20 mA
Analog input circuit common
Auxiliary voltage output: +24 VDC, max. 200 mA
Auxiliary voltage output common
Digital input common
Start forward: If DI1 = DI2, the drive stops.
Start reverse
Constant speed selection
Constant speed selection
Acceleration and deceleration selection
Relay output
No fault [Fault (-1)]
2)
SPEEDS: 0 = ramp times according to parameters
and 2203.
1 = ramp times according to parameters
and 2206.
3)
360 degree grounding under a clamp.
1)
1)
2)
2202
2205
Application macros
59