ABB ACS150 User Manual page 51

Parameter modes
There are two parameter modes: Short Parameter mode and Long Parameter mode.
Both function identically, except that the Short Parameter mode shows only the
minimum number of parameters typically required to set up the drive (see section
Parameters and signals in the Short Parameter mode
Parameter mode shows all user parameters including those shown in the Short
Parameter mode.
In the Parameter modes, you can:
• view and change parameter values
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
How to select a parameter and change its value
Step Action
1. Go to the Main menu by pressing
otherwise by pressing
2. If the panel is not in the desired Parameter mode ("PAr S"/"PAr L" not
visible), press key
mode) or "PAr L" (Long Parameter mode), as appropriate.
3. Short Parameter mode (PAr S):
• Press . The display shows one of the parameters of the Short
Parameter mode. Letter s in the top right corner indicates that you are
browsing parameters in the Short Parameter mode.
Long Parameter mode (PAr L):
• Press . The display shows the number of one of the parameter
groups in the Long Parameter mode.
• Use keys
• Press . The display shows one of the parameters in the selected
group.
4. Use keys
5. Press and hold
value of the parameter with
value is now possible.
Note: When
SET
simultaneously changes the displayed value to the default value of the
parameter.
if you are in the Output mode,
repeatedly until you see MENU at the bottom.
or until you see "PAr S" (Short Parameter
and to find the desired parameter group.
and to find the desired parameter.
for about two seconds until the display shows the
underneath indicating that changing of the
SET
is visible, pressing keys and
on page 64). The Long
Display
rEF
LOC
MENU
PAr S
LOC
MENU
PAr L
LOC
MENU
1202
LOC
PAR
-01-
LOC
PAR
-12-
LOC
PAR
1202
LOC
PAR
1203
LOC
PAR
100
LOC
.
PAR SET
Control panel
51
FWD
FWD
FWD
s
FWD
FWD
FWD
FWD
FWD
Hz
FWD