ABB ACS150 User Manual page 53

Changed Parameters mode
In the Changed Parameters mode, you can:
• view a list of all parameters that have been changed from the macro default
values
• change these parameters
• start, stop, change direction, switch between local and remote control and set the
frequency reference.
How to view and edit changed parameters
Step Action
1. Go to the Main menu by pressing
otherwise by pressing
2. If the panel is not in the Changed Parameters mode ("PArCh" not visible),
press key
display shows the number of the first changed parameter and PAR is
flashing.
3. Use keys
list.
4. Press and hold
value of the parameter with
value is now possible.
Note: When
SET
simultaneously changes the displayed value to the default value of the
parameter.
5. Use keys
changed the parameter value,
• To save the displayed parameter value, press
• To cancel the new value and keep the original, press
if you are in the Output mode,
repeatedly until you see MENU at the bottom.
or until you see "PArCh" and then press
and to find the desired changed parameter on the
for about two seconds until the display shows the
underneath indicating that changing of the
SET
is visible, pressing keys
and to select the parameter value. When you have
starts flashing.
SET
. The
and
.
.
Display
rEF
LOC
MENU FWD
PArCh
LOC
MENU FWD
1103
LOC
PAR FWD
1003
LOC
PAR FWD
1
LOC
PAR SET FWD
2
LOC
PAR SET FWD
1003
LOC
PAR FWD
Control panel
53