ABB i-bus KNX
3.2.5
Parameter window
"Controller PWM heating"
© 2009 Busch-Jaeger Elektro GmbH – A Company of the ABB Group
Commissioning
Invert heating
Options:
- Yes
- No
"Invert heating" is used to adjust the direction of control action of the control
value to "de-energised open" or "de-energised closed" valves.
Cycle time PWM control value (min)
Options:
- 1 / 2 / ... / 10 / ... /60
With PWM control, the actuator switches the valve drive depending on
the control value. The control thereby checks the "Cyclic time of the PWM
control value".
Example: for a cyclic time of 10 min. and a control value of 60%, the valve
gear is switched on for 6 min. and off for 4 min.
Basically, the following applies for cyclic time: the more inactive the entire
system, the higher the cyclic time you can set.
This parameter is only available if the "Heating" or "Heat and cool" control
functions are used and the heating control type is set to "PWM".
29