Mitsubishi Electric AG-150A Instruction Book page 37

(3) When monitoring remotely or sending error mail via a dial-up router, enter the router IP address in the [Gateway] field. Leave the
gateway address blank when not connecting via a dial-up router.
Note: It is recommended to set the dial-up router IP address to [192.168.1.254]. Refer to the dial-up router instruction manual for
details of how to set the IP address.
Note: It is necessary to connect a modem (analog type or ISDN type) between the dial-up router and telephone line when using
a dial-up router that does not have a built-in modem.
Gateway Address button
(4) Press [Save setting] on the network window to save the setting.
5-5-1-2 Settings for when the AG-150A is connected to an existing LAN
When connecting the AG-150A to an existing LAN, consult with the network administrator who is responsible for the LAN before
setting the IP address, subnet mask, or gateway address.
5-5-2 M-NET Setting
In M-NET Setting, set the AG-150A M-NET address, whether or not a K-Control unit is present and which machines send the prohibited
controller command.
(1) Enter the AG-150A M-NET address in the [M-NET Address] field. Normally you should enter [0].
(2) When K-Control air conditioners are connected, enter the M-NET address of K transmission converter in the [K Converter Address] field.
(3) If prohibited controller (prohibiting local operation) has been set, this setting determines the scope of this setting s control, i.e. operation is prohibited for
both the remote control and subordinate system controllers, or just for the remote control. Click [SC/RC] when you want prohibited controllers to include
both subordinate system controllers and the remote control, or touch [RC only] when you only want to prohibit operation on the remote control.
Note: Normally, you should select [SC/RC].
(4) Press [Save setting] on the network window to save the setting.
5-5-3 External input Setting
The external input function allows for a batch operation (start/stop) of the air conditioning units that are connected to the AG-150A via the
external input/output adaptor (PAC-YG10HA; sold separately), using contact and pulse signals.
Pressing the "External Input Setting" button toggles through the following options: Not in use, Emergency Stop (Level signal), ON/OFF
(Level signal), and ON/OFF/Prohibit/Permit (Pulse signal).
* See Chapter 8 for detailed explanations on how to connect external devices.
– 35 –
M-NET Address button
K Converter Address button
Range of Prohibited Controllers
button
External Input Setting button