Network Setting - Mitsubishi Electric AG-150A Instruction Book

5-4-3 Adjusting the sound volume and screen brightness
Sound volume and screen brightness are adjusted on this window.
Sound button
(1) Each touching of the sound volume control button cycles through the following: [Level 0], [Level 1], [Level 2], and [Level 3]. Although
the change made in sound volume is reflected right away, it will not be saved until the [Save setting] button is touched. Even if the
setting is changed, if the user exits the window without touching the [Save setting] button, the volume setting will go back to the
previous setting.
(2) Each touching of the brightness control button cycles through the following: [70 %], [80 %], [90 %], and [100 %]. Although the change
made in brightness is reflected right away, it will not be saved until the [Save setting] button is touched. Even if the setting is changed,
if the user exits the window without touching the [Save setting] button, the brightness setting will go back to the previous setting.
(3) Press [Save setting] on the Unit info window to save the setting.

5-5 Network Setting

Touch the [Network] tab in the screen that appears when [Initial Settings] on the menu bar in the setting change window is touched to
open the network setting window and make the basic settings for LAN and M-NET.
Note: If the user logs in as a building manager, some of the operations may be prohibited.
IP address input
button
Subnet mask
input button
Gateway address
input button
5-5-1 LAN setting
In Network Setting, set the AG-150A IP address, subnet mask and gateway address. If connecting to the AG-150A via a permanent
LAN, consult with the network administrator before setting these addresses.
5-5-1-1 Settings for when the AG-150A is connected to a dedicated LAN
(1) Set the IP address for AG-150A. Enter the IP address on the keyboard that appears when the IP address input button is touched.
If the LAN wiring has been newly set up, allocate IP addresses to the AG-150A units in a sequential order starting with
[192.168.1.1]. For example the first AG-150A unit will receive an IP address of [192.168.1.1], the second AG-150A unit will
receive an IP address of [192.168.1.2] and so on.
The Web Monitor PC that monitors and sets AG-150A will also require network addresses consistent with the rest of the LAN.
Note: When using a AG-150A dedicated LAN, it is recommended to set the IP address as follows.
AG-150A: Between [192.168.1.1] and [192.168.1.40] Web Monitor PC: Between [192.168.1.101] and [192.168.1.150]
IP Address button
(2) Set the subnet mask. Enter the subnet mask address for the AG-150A on the keyboard that appears when the subnet mask input
button is touched. Normally, you should enter [255.255.255.0].
Subnet Mask button
– 34 –
Brightness button
M-NET address
input button
K converter
address input
button
Controller setting
(prohibition of local
control)
External input
setting button
Save Settings