Xilinx KCU105 User Manual page 41

To run a simulation in the Vivado Design Suite Simulator:
1. In the Flow Navigator Panel, under Simulation, click Simulation Settings.
2. In the Project Settings window, select Vivado Simulator in the Target simulator field
and click Yes when asked if it is OK to change your target simulator to Vivado Simulator.
Click OK in the Project Settings window
X-Ref Target - Figure 4-14
3. In the Flow Navigator Panel, under Simulation, click Simulation > Run behavioral
simulation.
When simulating the design on Windows, use this command to prevent the path length
IMPORTANT:
from exceeding 260 bytes:
exec subst A:<working dir>\rdf0308-kcu105-trd04-2016-1\kcu105_10gbaser_trd\hardware
10GBASE-R Ethernet TRD
UG921 (v2016.3) October 25, 2016
Figure 4-14: Set simulator to Vivado Simulator
www.xilinx.com
Chapter 4: Implementing and Simulating the Design
(Figure 4-14).
41
Send Feedback