Maintenance Screen; Copying The Data To A Usb Memory - Mitsubishi Electric AG-150A Instruction Book

Table Available Function List
Date and time
Unit Info
Network
Advanced
Groups
Initial setting
Interlock
Blocks
Floor Layout
Function 1 Measurement
Ext Temp Interlock
Function 2
Setback
*1: At factory shipment, the operation of the building manager is prohibited.

11. Maintenance screen

11-1 Copying the data to a USB memory

Note:

The table below shows USB memory devices that have been confirmed to work. (As of February 2012)
No. Manufacturer
1 Sandisk
2 kingston
3 I/O data
4 I/O data
5 BUFFALO
6 BUFFALO
7 BUFFALO
8 BUFFALO
9 adata
* Asterisks in the Model column describe colors.
Do not make a security function setting when using No.10, 12, 13, or 14.

If any USB memory above cannot be obtained, use a memory device that meets the following three conditions. Test the memory
device several times before use and verify that the device functions properly.
Reading data from or writing data to a memory device that has not been confirmed to work may cause unexpected problems.
Make sure to test the memory device before operating the unit (during the test run). Do not use a memory device that has
experienced writing error once.
To copy the data to a USB drive, plug the USB into a USB port, and touch [Backup] in the screen that appears when [Maintenance] on
the setting change screen is touched.
Function
*1
*1
*1
Group name
Group structure
*1
Block name
Block structure
Floor name
Floor configuration
Model
SDCZ6-2048-J65RB
DT400/2GBFE
TB-BH2/2G/*
TB-BH2/4G/*
RUF-C2GS-**/U2
RUF2-C2GS-**/M
RUF-C4GS-**/U2
RUF-C8GS-**/U2
C702
1 USB standard: Verified with USB 1.1
2 Format type: Must be in FAT32 or FAT (FAT16) format
3 Security function is not provided, or not required to set.
USB port
Current date and time setting
AG-150A unit information settings, connection or non-connection of EC
AG-150A network setting, external output setting
AG-150A Time Master/Sub setting, Seasonal schedule setting
Group name setting
Connection setting of indoor units, LOSSNAY units, DIDO controller,
*1
Air To Water (PWFY), remote controllers, and system controllers in a
group
Connection setting of interlocked LOSSNAY
Block name setting
*1
Registration setting of groups in a block
Floor name setting
Floor configuration setting
Setting of AI controller, PI controller
Setting of outside temperature interlock function
Setting of setback function
Capacity No. Manufacturer
2G 10 Verbatim
2G 11 SILICON POWER
2G 12 ELECOM
4G 13 Transcend
2G 14 TDK
2G 15 BUFFALO
4G
8G
2G
– 95 –
Content
Model
USBM4GVWS1
SP002GBUF2M01V1*
MF-NU2A04G**
TS2GJFV33
UFD4GS-T*A
RUF2-K4GE-**
Capacity
4G
2G
4G
2G
4G
4G