Mitsubishi Electric AG-150A Instruction Book page 42

6-3-2 Setting the schedule with a registered license
When a license (PIN CODE) is registered, it is possible to set different weekly (5 types)/annual/today's schedules for each air conditioner
group. Moreover, for any weekly/annual/today's schedule run for a particular day, the priority in which it is run will be from the highest and
the order will be [Today's], [Annual], [Weekly 1], [Weekly 2], [Weekly 3], [Weekly 4], [Weekly 5]. Five types of weekly schedule can be set.
6-3-2-1 Setting the Weekly Schedule
Touch the menu item [Schedule Settings] and touch [Weekly 1] - [Weekly 5] in the sub menu to display the Weekly Schedule setting
screen. To set a weekly schedule, you first must select what will be the target of this schedule and then set the schedule details from
Sunday right through to Saturday.
Note: If today's schedule has been set, it will override the scheduled settings for the date in the weekly schedule.
Note: When the contents of an operation are executed as part of a schedule these contents will continue to be in effect until they are
changed by a schedule or browser etc. Therefore, if you are setting a schedule that is only for a particular day, be sure to set
your schedule in a way that will not impact on the next day's operation.
For example, if you wish to prohibit operations being performed from the remote controller after 17:00, set a Prohibit operation
for 17:00 and set an Enable operation for 23:59.
Note: The weekly schedules of the groups whose schedule settings are Not Available from the control screen will not be executed.
(Refer to section 6-2.)
*For a system connected to TG-2000A Ver. 6.36 or before, only [Weekly 1] and [Weekly 2] are available.
*If the Season setting is set to "Not Available" on the Advanced settings screen, the Weekly schedule settings cannot be valid.
(1) Select the schedule to set.
Weekly 1 Floor display
Weekly 1 HWHP (CAHV) display
(2) Select the type of schedule settings to make.
Select the type of schedule settings to make by referring to Section 1 above under "Select the type of schedule settings to
make."
Select one of the sub menus [Weekly 1] through [Weekly 5].
(Five types of weekly schedule patterns are available if the license is
registered.)
When HWHP (CAHV) units are connected, the [HWHP] tab will be
displayed on the sub menus [Weekly1] - [Weekly5] along with the
[Floor] and [Block] tabs. Selecting the [HWHP] tab will display the
information about the HWHP (CAHV) units only.
– 41 –