ABB i-bus KNX Product Manual page 34


ABB i-bus KNX
Commissioning
32 2CDC 508 101 D0201 | VAA/S x.230.2.1
Send object value
(Object "Fault control value" 1 bit)
Options: no, update only
after a change
after request
after a change or request

no, update only: The status is updated but not sent.

after a change: The status is sent after a change.

after request: The status is sent after a request.

after a change or request: The status is sent after a change or a request.
Control value after controller fault
in % [0...100]
Options: 0...30...100
The value for the control of the output in percent is determined here when the control value is not
displayed.
If a control value is received via a 1 bit value, on parameter
page 30, a value must be entered. This value is used as the basis for calculation of the output
control at control fault in %.
Cycle time of PWM in s [10...6,000],