ABB i-bus KNX Product Manual page 29


ABB i-bus KNX
Commissioning
Enable communication object
"Status man. operation" 1 bit
Options: no
yes

yes: The 1 bit communication object Status manual operation (no. 2) is enabled. An additional
parameter appears:
Send object value
Options: no, update only
after a change
after request
after a change or request

no, update only: The status is updated but not sent.

after a change: The status is sent after a change.

after request: The status is sent after a request.

after a change or request: The status is sent after a change or a request.
VAA/S x.230.2.1 | 2CDC 508 101 D0201 27