Hydraulic Brake; Brake Components; Brake Fluid; Brake Hoses - Toro UTV500AAC00000 Operator's Manual

3. Drain the lubricant into a drain pan by
removing the drain plug from the
front differential and rear drive.
4. After all the lubricant has been
drained, install the drain plugs and
tighten to 5 N-m (45 in.-lb).
CAUTION
Inspect the oil for any signs of metal
filings or water. If found, take the
vehicle to an authorized Toro ROV
dealer for servicing.
5. Pour SAE approved 80W-90 hypoid
lubricant into each fill hole until it
flows out of the hole.
6. Install the fill plugs and tighten to 22
N-m (16 ft-lb).

Hydraulic Brake

! WARNING
Be sure to inspect the hydraulic
brake system before
Always maintain brakes according to
the Maintenance Schedule.

Brake Fluid

1. Check the brake fluid level in the brake
fluid reservoir. The fluid level must be
CF107A
maintained between the MAX and MIN
level marks. If the level in the reservoir
is low, add DOT 4 approved brake fluid.

NOTE: The brake fluid reservoir is
located on top of the master cylin-
der under the hood.
2. Press the brake pedal several times to
check for firmness.
3. If the pedal is not firm, the system
CF106A
must be bled.

NOTE: Take the vehicle to an autho-
rized Toro ROV dealer for this service.
Be careful not to spill any fluid when
filling the brake fluid reservoir. Wipe
away spilled fluid immediately.

Brake Hoses

Carefully inspect the hydraulic brake hoses
for cracks or other damage. If found, take
the vehicle to an authorized Toro ROV
dealer to have the brake hoses replaced.
Brake Pads
The clearance between the brake pads
and brake discs is adjusted automatically
as the brake pads wear. The only mainte-
nance that is required is replacement of
the brake pads when they show excessive
each use.
wear. Check the thickness of each of the
brake pads as follows:
1. Remove a front wheel.
2. Measure the thickness of each brake
pad.
HDX081A
CAUTION
41