Checking/Adjusting Headlight Aim; Fuses - Toro UTV500AAC00000 Operator's Manual

3. Install the new bulb into the housing;
then install the housing and rotate it
completely clockwise.
4. Install the wiring harness connector.
To replace the taillight/brakelight bulb,
use the following procedure.
1. Remove the mounting screws secur-
ing the taillight/brakelight assembly
to the rear ROPS tube.
2. Rotate the socket counterclockwise
and remove it from the housing.
3. To remove the bulb from the socket,
pull it straight out of the socket.
4. To install the bulb, push it straight
into the socket.
5. Insert the socket into the housing and
rotate it clockwise.
6. Position the taillight/brakelight
assembly on the rear ROPS tube; then
tighten the mounting screws securely.
Checking/Adjusting
Headlight Aim
The headlights can be adjusted vertically.
The center of the HIGH beam light zone
is to be used for aiming.
1. Position the vehicle on a level floor
so the headlights are approximately
6.1 m (20 ft) from an aiming surface
(wall or similar aiming surface).

NOTE: There should be an aver-
age operating load on the vehicle
when adjusting the headlight aim.
2. Measure the distance from the floor
to the mid-point of each headlight.
50
3. Using the measurements obtained in
step 2, make horizontal marks on the
aiming surface.
4. Make vertical marks which intersect
the horizontal marks on the aiming
surface directly in front of the head-
lights.
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the HIGH beam is
centered on the vertical mark 5 cm (2
in.) below the horizontal mark on the
aiming surface.
7. Turn the adjuster nut clockwise to
raise the beam and counterclockwise
to lower the beam.

Fuses

The fuses are located in a power distribu-
tion module under the driver seat. If there
is any type of electrical system failure,
always check the fuses first.

NOTE: To remove the fuse cover,
compress the locking tabs on either
side of the fuse cover and lift out.
0740-647
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Toro ROV dealer immediately.
TC004A
3411-968