Occupant Side Restraints; Cargo Box - Toro UTV500AAC00000 Operator's Manual


NOTE: To remove the seat base
and seat back, first remove the four
screws securing the seat back and
set the seat back aside. Remove the
screws securing the seat base and
set the seat base aside.
Seat Belts
This vehicle is equipped with seat belts
for the operator and two passengers. To
fasten and release the seat belt properly,
use the following procedure.
1. Place the seat belt across your lap as
low as possible without twisting the
belt making sure the shoulder strap is
below the neck and across the chest.
! WARNING
Only appropriate-sized passengers
may ride in this vehicle. Passengers
must be able to place both feet flat on
the floor while keeping their back
against the back of the seat and hold-
ing on to available hand holds.
2. Push the latch-plate into the buckle
slot until it "clicks" and latches
securely. The belt will retract when
the buckle is released.
! WARNING
Falling outside a moving vehicle
could result in serious injury or
death. Always fasten your seat belt
securely and ensure the passenger
seat belt is properly and securely fas-
tened prior to operating or riding in
this vehicle.
Occupant Side
Restraints
In addition to the seat belts, there are left-
and right-side restraints to restrict arms
or legs from extending outside the vehi-
cle. The restraints should always be
secured when the vehicle is moving.
To secure the restraint, connect the
restraint buckle to the foot restraint latch
bracket. To release the restraint, press the
release button in the center of the buckle.
26

Cargo Box

The cargo box on this ROV can be con-
verted to a "flat-bed" cargo platform. To
convert your cargo box to a flat-bed, use
the following procedure.
1. Remove all cargo from the box; then
remove the left and right forward tie
bolts.
2. Raise the cargo box; then loosen the
four retaining bolts securing the side
panels in the stake pockets; then
lower the box.
HDX187A
HDX188
TC006