Light Bulb Replacement; Headlight/Taillight-Brakelight - Toro UTV500AAC00000 Operator's Manual

2. Remove the muffler by pulling it
rearward out of the vehicle.
3. Remove the heat shield.
4. Remove the three cap screws secur-
ing the exhaust pipe/spark arrester
assembly to the muffler.
5. Using a wire brush, clean the carbon
deposits from the screen taking care
not to damage the screen.
HDX238A

NOTE: If the screen or gasket is
damaged in any way, it must be
replaced.
6. Install the exhaust pipe/spark arrester
assembly and secure with the three
cap screws. Tighten to 6.8 N-m (60
in.-lb).
7. Install the heat shield and tighten the
fasteners to 8.1 N-m (72 in.-lb).
8. Install the muffler and secure it to the
exhaust pipe with the two springs.

Light Bulb Replacement

HDX241A
The wattage rating of each bulb is shown
in the chart. When replacing a burned out
bulb, always use the same wattage rating.
Headlight
Taillight/Brakelight
CAUTION
Use only specified bulbs indicated in
the chart as replacement bulbs.
CAUTION
The bulb portion of the headlight is
fragile. HANDLE WITH CARE. When
replacing the headlight bulb, do not
HDX243A
touch the glass portion of the bulb. If
the glass is touched, it must be
cleaned with a dry cloth before
installing. Skin oil residue on the bulb
will shorten the life of the bulb.
To replace the headlight bulb, use the fol-
lowing procedure.
1. Remove the wiring harness connector
from the back of the headlight.
2. Grasp the bulb housing, turn it coun-
terclockwise, and remove the hous-
ing. Remove the bulb.
HDX242
12V/27W (4)
12V/8W/27W
49