Toro UTV500AAC00000 Operator's Manual page 32

The LCD will go blank except the
word VOLT will flash on the LCD
whenever a low voltage (<9 DC volts)
or a high voltage (>16 DC volts) is
detected. When voltage returns to nor-
mal, the gauge must be reset by turning
the ignition key to the OFF position
and then to the ON position.
A diagnostic trouble code (DTC) will
flash on the LCD whenever an elec-
tronic fuel injection (EFI) system
error is detected. After 30 seconds,
the gauge will return to normal, but
the code will continue to flash until
the malfunction is corrected.

NOTE: Take the ROV to an autho-
rized Toro ROV dealer to have the
error corrected and the system error
reset as soon as possible.
2. Fuel Level Indicator - Indicates
approximate amount of gasoline in
the gas tank.

NOTE: When the bottom segment
flashes, approximately 3.5 L (0.92 U.S.
gal.) of gasoline remains in the tank.
3. Mode Button - Press and release to
shift the gauge between MPH or km/h
and RPM. Press and hold to switch
between MPH and km/h.
4. Set/Reset Button - Press and release
to shift between Odometer, Trip 1,
Trip 2, Engine Hour Meter, and
Clock. Press and hold while Trip 1 or
Trip 2 are selected to clear the
selected trip. The odometer cannot be
reset.
5. Odometer/Trip Meter/Clock/Engine
Hour Meter - Displays odometer
(total distance the vehicle has trav-
eled) or one of two trip meters used to
measure trips or trip legs correspond-
ing to the function selected (MPH or
km/h). The clock function indicates
time in the 12 hour mode. The hour
meter indicates the total time the
ROV has run and cannot be reset to
zero. To set the clock, use the follow-
ing procedure.
30
A. With the ignition switch ON, press
and release the Mode Button until
the Clock/Engine Hour Meter is
displayed; then (if necessary) press
and release the Set/Reset Button to
the clock display.
B. Press and hold Set/Reset Button
until minutes stop scrolling and the
hour display starts to scroll.
Momentarily release when correct
hour is displayed; then repeatedly
press and release Set/Reset Button
until correct minutes are displayed.

NOTE: Approximately two seconds
after releasing either Button, the
LCD will return to normal operation.

NOTE: Clock memory power is
supplied through the 15-amp acces-
sory fuse and verified during gauge
"power-up" and reset. In the event of
clock memory power failure (blown
fuse, etc.), the gauge will "power-
up," reset, and shut down repeatedly
until clock memory
restored. Always check the 15-amp
accessory fuse if this gauge condi-
tion is noted.

NOTE: The engine hour meter will
not activate until engine speed
exceeds 500 RPM.
6. Gear Position Indicator - Indicates
which gear is selected - R (reverse)/N
(neutral)/H (high
range)/P (park).

NOTE: An E will be displayed if
there is an error caused by a no-shift
position signal.
7. Engine Hour Meter Indicator - Indi-
cates engine hour meter mode is
selected on the display.
8. Speedometer/Tachometer Indicator -
Indicates which mode (MPH, km/h,
or RPM) is being displayed.
9. 4WD Lock Indicator (700 only) -
Displays LOCK when the front dif-
ferential lock has been engaged.
10. Drive Select Indicator - Displays
4WD when selected by the drive
select switch or when the 4WD lock
is engaged. The display is blank when
in 2WD.
power is
range)/L (low