Using The Cylinder Locks; Using Attachments - Toro 22318 Operator's Manual

Using the Cylinder Locks

The loader arms may lower when in the raised
position crushing anyone under them.
Install the cylinder locks before performing
maintenance that requires raised loader arms.
Installing the Cylinder Locks
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Position a loader arm cylinder lock over each lift
cylinder rod (Figure 11).
5. Secure each loader arm cylinder lock with a clevis
pin and cotter pin (Figure 11).
Figure 11
1. Cylinder lock
2. Lift cylinder
3. Hairpin cotter
6. With the engine off, lower the loader arms.
4. Clevis pin
5. Lift cylinder rod
Removing/Storing the Cylinder Lock
1. Start the engine.
2. Raise the loader arms to the fully raised position.
3. Stop the engine.
4. Remove the clevis pin and cotter pin securing each
cylinder lock.
5. Remove the cylinder locks.
6. Lower the loader arms.
7. Install the cylinder locks over the hydraulic hoses
and secure them with the clevis pins and cotter pins
(Figure 12).
1. Hydraulic hoses
2. Cylinder locks

Using Attachments

Installing an Attachment
Important: Use only Toro-approved attachments.
Attachments can change the stability and the
operating characteristics of the traction unit. The
warranty of the traction unit may be voided if used
with unapproved attachments.
Important: Before installing the attachment,
ensure that the mount plates are free of any dirt or
debris and that the pins rotate freely. If the pins do
not rotate freely, grease them.
1. Position the attachment on a level surface with
enough space behind it to accommodate the
traction unit.
2. Start the engine.
3. Tilt the attachment mount plate forward.
4. Position mount plate into the upper lip of the
attachment receiver plate (Figure 13).
18
Figure 12
3. Hairpin cotter
4. Clevis pin