Specifications; Attachments/Accessories; Stability Data - Toro 22318 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width
Length
Height
Weight (without attachment or
counterweight)
Weight of the counterweight
Operating capacity (with 200 lb operator,
the standard bucket, and without the
counterweight)
Tipping capacity (with 200 lb operator,
the standard bucket, and without the
counterweight)
Wheelbase

Stability Data

The following tables list the maximum slope recommended for the traction unit in the positions listed in the tables.
Slopes over the listed degree may cause the traction unit to become unstable. The data in the tables assume that the
loader arms are fully lowered; raised arms may affect the stability.
In each attachment manual is a set of three stability ratings, one for each hill position. To determine the maximum
slope you can traverse with the attachment installed, find the degree of slope that corresponds to the stability ratings
of the attachment. Example: If the attachment has a Front Uphill rating of B, a Rear Uphill rating of D, and a
Side Uphill rating of C, then you could drive forward up an 20° slope, rearward up a 10° slope, or sideways on a
13° slope, as listed in the following table.
Configuration
Traction unit without attachment
Traction unit with counterweight, without attachment
Traction unit with an attachment rated with one of the following stability ratings
for each slope position:*
A
B
C
D
E
40.5 inches (103 cm)
60 inches (152 cm)

Attachments/Accessories

49 inches (125 cm)
1567 lb (711 Kg)
A selection of Toro approved attachments and
accessories are available for use with the machine to
180 lb (81.6 Kg)
enhance and expand its capabilities. Contact your
515 lb (234 Kg)
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
1030 lb (467 Kg)
Important: Use only Toro approved attachments.
Other attachments may create an unsafe operating
28 inches (71 cm)
environment or damage the traction unit.
13
Dump height (with standard bucket)
Reach—fully raised (with standard
bucket)
Height to hinge pin (narrow bucket in
standard position)
Maximum Recommended Slope when
Front Uphill
10°
8°
25°
20°
15°
10°
5°
47 inches (120 cm)
26 inches (66 cm)
66 inches (168 cm)
Operating with:
Rear Uphill Side Uphill
20° 18°
20° 19°
25° 20°
20° 17°
15° 13°
10° 9°
5° 5°