Toro 22318 Operator's Manual page 19

Figure 13
1. Mount plate
5. Raise the loader arms while tilting back the mount
plate at the same time.
Important: The attachment should be raised
enough to clear the ground, and the mount
plate should be tilted all the way back.
6. Stop the engine.
7. Engage the quick attach pins, ensuring that they are
fully seated in the mount plate (Figure 14).
Important: If the pins do not rotate to the
engaged position, the mount plate is not
fully aligned with the holes in the attachment
receiver plate. Check the receiver plate and
clean it if necessary.
2. Receiver plate
1. Quick attach pins (shown
in engaged position)
2. Disengaged position
If you do not fully seat the quick attach pins
through the attachment mount plate, the
attachment could fall off of the traction unit,
crushing you or bystanders.
Ensure that your quick attach pins are fully
seated in the attachment mount plate.
Connecting the Hydraulic Hoses
If the attachment requires hydraulics for operation,
connect the hydraulic hoses as follows:
1. Stop the engine.
2. Move the auxiliary hydraulics lever forward,
backward, and back to neutral to relieve pressure
at the hydraulic couplers.
3. Move the auxiliary hydraulics lever forward into the
detent position.
4. Remove the protective covers from the hydraulic
couplers on the traction unit.
5. Ensure that all foreign matter is cleaned from the
hydraulic connectors.
19
Figure 14
3. Engaged position