Installing The Seat; Installing The Motion Control Levers - Toro Z400 Series Z Master Setup Instructions

Step
5

Installing the Seat

Parts Needed for This Step
None
Procedure
1. Remove the seat from the crate.
2. Remove the bolt
and nut from the seat
frame.
3. Secure the seat rod
to the seat with the bolt
and nut.
Step
6
Installing the Motion
Control Levers
Parts Needed for This Step
Qty.
1 Control lever–right
1 Control lever–left
4 Bolt, 3/8 x 1 inch (2 assembled)
4 Curved washer, 3/8 inch (2 assembled)
m-5712
Part
5
Procedure
1. Rotate the control
levers to the upright
position.
2. Loosely install the
control levers on the
outside of the posts,
using 4 bolts and 4
curved washers.
Note: Install the control
levers in the top and
middle holes for the high
position or the middle
and bottom holes for the
low position, as desired.
3. Raise the levers and align them together in the
neutral position and tighten the bolts.
Note: If the machine is not properly tracking, refer to
Adjusting the Tracking in your Operator's Manual .
m-6866
m-6867
m-6868