Installing The Rollover Protection System (Rops) - Toro Z400 Series Z Master Setup Instructions

Step
2
Installing the Rollover
Protection System (ROPS)
Parts Needed for This Step
Qty.
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt, 3/8 x 1 inch
8 Curved washer
8 Flange nut, 3/8 inch
2 Bolt, 1/2 x 3-1/4 inches
2 Flange nut, 1/2 inch
2 Lanyard
Part
3
Procedure
1. Loosely install the right and left roll bar sections
to the frame, using 8 bolts (3/8 x 1 inch), 8 curved
washers, and 8 flange nuts (3/8 inch).
2. Install the lanyard
clips onto the 2 bolts
(1/2 x 3-1/4 inches).
Note: Make sure the
bent tab points toward
the head of the bolt.
3. Lightly oil the ends
of the center roll bar
section.
4. Loosely install the
center roll bar section,
using 2 bolts
(1/2 x 3-1/4 inches) and
2 flange nuts (1/2 inch).
Note: Make sure the
bolts are installed on the
outside of the roll bar.
Note: Make sure the
lanyard tab is installed
as shown and points
forward.
m-6916
m-7410
m-7432