Installing The Drive Wheels; Checking The Tire Pressure - Toro Z400 Series Z Master Setup Instructions

5. Raise the roll bar
into the upright position
and secure it with the
pins and hairpin cotter
pins fastened to the
lanyards.
6. Torque all the lower
fasteners that are
attached to the machine
frame to 30 ft-lb.
7. Tighten the center
roll bar bolts
(1/2 x 3-1/4 inches) so
that the roll bar rotates
freely with some
resistance.
Note: Make sure that no
more than one thread is
exposed outside the nut.
8. Tighten the front
handles against the
center roll bar ends.
4
Step
3

Installing the Drive Wheels

Parts Needed for This Step
m-7431
Qty.
m-7432
2 Rear wheels
Procedure
1. Mount the wheels
with the valve stem to
the outside and secure
them with the nuts you
previously removed in
step 1.
2. Torque the nuts to
95 ft-lb (128 N m).
Step
4
m-7406

Checking the Tire Pressure

Parts Needed for This Step
None
Procedure
Check the air pressure
in the front and rear tires
and make sure that they
are set to 13 psi
(90 kPa).
Part
m-6917
m-6873