Setup; Loose Parts; Installing The Drive Wheels; Checking The Tire Pressure - Toro 74179 Operator's Manual

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use the chart below to verify that all parts have been shipped.
Description
Rear wheels
Retaining rod
Bolt, 5/16 x 1 in.
Locknut, 5/16 in.
Control lever—right
Control lever—left
Bolt, 3/8 x 1 in.
Spring washer, 3/8 in.
Key
Operator's Manual
Engine Operator's Manual
Parts Catalog
Registration card

Installing the Drive Wheels

1. Uncrate the mower.
2. Remove the wheel bolts or nuts from the rear wheel
hubs.
3. Align the holes. Mount the drive wheels with the valve
stem to the outside of the traction unit.
4. Secure the wheels using the wheel bolts or nuts
provided. Torque to 95 ft.-lb. (128 N m).
Qty. Use
2 Installing the wheels to the traction unit
1
1 Installing the seat rod
1
1
1
Installing the motion control levers
4
4
2
1
Read before operating the machine.
1
1
1 Fill out and return to Toro.

Checking the Tire Pressure

Check the air pressure in the front and rear tires (Fig. 2).
Pressure: 13 psi (90 kPa)
1. Valve stem
14
1
Figure 2
m–1872