Cab Maintenance; Filling The Washer Fluid Bottle; Cleaning The Cab Air Filters - Toro 31202 Operator's Manual

Figure 41
1. Transmission case drain
plug
2. Filter
4. Clean the area around the hydraulic oil filter and
remove it (Figure 41).
5. Immediately install a new hydraulic oil filter.
6. Install the hydraulic reservoir and transmission case
drain plugs.
7. Fill the reservoir to the proper level (approximately
17 liters [18 quarts]); refer to Checking the Hydraulic
Fluid.
8. Start the engine and check for oil leaks. Allow the
engine to run for about five minutes, then shut it off.
9. After two minutes, check the level of the hydraulic
fluid; refer to Checking the Hydraulic Fluid.
3. Hydraulic reservoir drain
plug

Cab Maintenance

Filling the Washer Fluid Bottle

1. Stop the machine on a level surface, stop the engine,
set the parking brake, and remove the ignition key.
2. Open the hood.
3. Locate the washer fluid bottle
Washer Fluid Bottle with Washer Fluid Symbol
4. Fill the bottle with washer fluid as needed.
5. Close the hood.

Cleaning the Cab Air Filters

Service Interval: Every 250 hours (Replace them if they are
torn or excessively dirty.)
1. Remove the screws and grates from over both the
in-cab and rear cab air filters
44
(Figure 42).
Figure 42
(Figure 43).