Cab Controls - Toro 31202 Operator's Manual

Important: If the mower deck shuts down and the
InfoCenter temperature warning icon is on, push PTO
knob down, drive to a safe flat area, move the throttle
lever to the Slow position, allow the traction pedal to
move to the neutral position, and engage the parking
brake. Allow the engine to idle for several minutes while
it cools to a safe level. Stop the engine and check the
cooling system; refer to Checking the Cooling System.
Fuel Gauge
The fuel gauge (Figure 5) indicates the fuel level remaining
in the fuel tank.
1. Fuel gauge

Cab Controls

3
2
1
9
1. Air recirculation control
2. Fan control
3. Temperature control
4. Wind shield wiper switch
Figure 5
2. Fuel tank cap
4
8
g028431
7
Figure 6
5. Power outlet
6. Lights switch
7. Flashers switch
8. Air conditioning switch
Air Recirculation Control
Sets the cab to either recirculate the air in the cabin or to draw
air into the cabin from outside
•
Set it to recirculate the air when using the air-conditioning.
•
Set it to draw air in when using the heater or fan.
Fan Control
Rotate the fan control knob to regulate the speed of the fan
(Figure 6).
Temperature Control
Rotate the temperature control knob to regulate the air
temperature in the cab
Wind Shield Wiper Switch
Use this switch to turn the wind shield wipers on or off
(Figure 6).
Power Outlet
Use this 15 amp, 12 V DC power outlet to power compatible
devices (Figure
Lights Switch
Use this switch to turn the head lights and tail light on or
off (Figure 6).
Flashers Switch
Use this switch to turn the flashers (hazard lights) on or off
(Figure 6).
5
Air Conditioning Switch
6
Use this switch to turn the air conditioning on or off
6).
Wind Shield Latch
Lift up on latches to open the wind shield
in on latch to lock wind shield in open position. Pull out and
down on latch to close and secure wind shield.
14
(Figure 6).
(Figure 6).
6).
(Figure
(Figure 7). Press