Specifications; Attachments/Accessories - Toro 31202 Operator's Manual

LCD Backlight
LCD Contrast
Protected Menus
Auto Idle
* Only "operator-faced" text is translated. Faults, Service, and
Diagnostics screens are "service-faced". Titles will be in the
selected language, but menu items are in English.
About
Menu Item
Model
SN
Machine Controller Revision
InfoCenter Revision
CAN Bus
Protected Menus
There are 2 operating configuration settings that are adjustable
within the Settings Menu of the InfoCenter: auto idle time
delay and stationary regeneration. These settings can be
locked by using the Protected Menu.
Note: At the time of delivery, the initial password code is
programmed by your distributor.
Accessing the Protected Menu Settings
To access the Protected Menu Settings
•
From the Main Menu, scroll down to the Settings Menu
and press the right button.
•
In the Settings Menu, scroll down to the Protected Menu
and press the right button.
•
To enter the passcode, use the center button to set the
first digit then press the right button to move on to the
next digit.
•
Use the center button to set the second digit then press
the right button to move on to the next digit.
•
Use the center button to set the third digit then press the
right button to move on to the next digit.
•
Use the center button to set the fourth digit then press
the right button.
Controls the brightness of the
LCD display.
Controls the contrast of the
LCD display.
Allows the
superintendant/mechanic
to access protected menus by
inputting a passcode.
Controls the amount of time
allowed before returning the
engine to low idle when the
machine is stationary.
Description
Lists the model number of the
machine.
Lists the serial number of the
machine.
Lists the software revision of
the master controller.
Lists the software revision of
the InfoCenter.
Lists the machine
communication bus status.
•
Press the middle button to enter the code.
•
If the code has been accepted and the protected menu has
been "Unlocked", "PIN" will be displayed in the upper
right corner of the display screen.
The ability to view and change the settings in the Protected
Menu can be changed. Once the Protected Menu has been
accessed, scroll down to Protect Settings. Using the right
button, changing Protect Settings to OFF will allow the
ability to view and change the settings in the Protected Menu
without entering the passcode. Changing Protect Settings to
ON will hide the protected options and will require entering a
passcode to change the setting in the Protected Menu. After
the pass code has been set, the key switch must be turned off
and back on to enable and save this feature.
Note: If the passcode has been forgotten or misplaced,
please contact your distributor for assistance.
To Set the Auto Idle
•
In the Settings Menu, scroll down to Auto Idle.
•
Press the right button to change the auto idle time
between OFF, 8S, 10S, 15S, 20S, & 30S.
Stationary Regeneration
If the Stationary Regeneration icon appears on the InfoCenter,
refer to the Service Manual or contact your Toro Distributor
for the maintenance procedure.
DPF Ash Level
The DPF ash level may be checked by entering the PIN as
described in Accessing the Protected Menu Settings and
navigating to the service section.

Specifications

Note: Specifications and design are subject to change
without notice.
Length
Width (Rear Wheels)
Height
Weight

Attachments/Accessories

A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
18
241.3 cm (95 inches)
147.3 cm (58 inches)
221 cm (87 inches)
1435 kg (313 lb)