Toro 41177 Multi-Pro 1250 Operator's Manual page 32

10. Allow all of the water in the tank to spray out
though the nozzles.
11. Check the nozzles to ensure that they are all
spraying correctly.
12. Set the master boom switch to the Off
position, set the pump switch to the Off
position, and stop the engine.
13. Repeat steps 4 through 12 at least 2 more times
to ensure that the spray system is fully cleaned.
On the last cycle, run the last few gallons of
water through the drain valve to clear the drain
tubing.
14. Clean the strainer; refer to Cleaning the Suction
Strainer inCleaning, page 59.
Important: If you used wettable powder
chemicals, clean the strainer after each
tank.
15. Using a garden hose, spray off the outside of
the sprayer with clean water.
16. Remove the nozzles and clean them by hand.
Replace damaged or worn nozzles.
32