Controls - Toro 41177 Multi-Pro 1250 Operator's Manual

Controls

1. Steering wheel
2. Spray-Pro monitor
3. Speed limiter
Accelerator Pedal
The accelerator pedal (Figure 12) gives you
the ability to vary ground speed of the sprayer.
Pressing the pedal increases ground speed.
Releasing the pedal will slow the sprayer and the
engine will idle.
Figure 12
1. Brake pedal
Figure 11
4. Choke
5. Sprayer controls
6. Rate lockout switch
2. Accelerator pedal
7. Parking brake
8. Master boom foot switch
9. Range Selector
Brake Pedal
Use the brake pedal to stop or slow the sprayer
(Figure 12).
Brakes can become worn or can be adjusted
incorrectly resulting in personal injury.
If brake pedal travels to within 1 inch
(2.5 cm) of the sprayer floor board, the
brakes must be adjusted or repaired.
Parking Brake
The parking brake is a large lever to the right of
the seat. (Figure 13). Engage the parking brake
whenever you plan on leaving the seat to prevent
accidental movement of the sprayer. To engage
the parking brake, pull up and back on the lever.
To disengage, push it forward and down. If the
sprayer is parked on a steep grade, apply the
parking brake and place blocks at the downhill
side of the wheels.
18
10. Voltmeter
11. Hour meter
12. Vehicle controls