Toro 41177 Multi-Pro 1250 Operator's Manual page 31

Figure 26
1. Rinse tank (for use with the optional rinse kit, 106-4842)
1. Stop the sprayer, set the parking brake, place
the range selector in the Neutral position, and
turn off the engine. The tank will drain to left
side of the machine.
2. Locate the tank drain valve on the left side of
the machine (Figure 27). The valve is on the
frame in front of the fuel tank.
Figure 27
1. Tank drain handle
Open the valve to drain any unused material
from the tank and dispose of it according to
local codes and the material manufacturer's
instructions (Figure 28). After draining,
remove the lynch pin on the bracket securing
the drain valve to the machine and let the valve
rest on the ground . This allows any residual
material in the line to drain.
2
Figure 28
1. Valve open
2. Lynch pin
3. When the tank has drained completely, install
the valve to frame with the lynch pin removed
previously and close the drain valve (Figure 28).
4. Fill the tank with at least 50 US gallons (190 L)
of clean fresh water and close the cover.
Note: You can use a cleaning/neutralizing
agent in the water as needed. On the final
rinse, use only clean, clear water.
5. Start the engine.
6. With the range selector in the Neutral position,
press the accelerator pedal to the floor and set
the neutral engine speed lock switch to the On
position.
7. Ensure that the agitation control valve is in the
On position.
8. Set the pump switch to the On position and
use the application rate switch to increase the
pressure to a high setting.
9. Set the master boom switch and boom control
switches to the On positions to begin spraying.
31
3
1
G005482
3. Valve closed