Cleaning; Cleaning The Flowmeter; Cleaning The Suction Strainer - Toro 41177 Multi-Pro 1250 Operator's Manual

Figure 73
1. Pivot pin
2. Bolt
3. Nut
4. Remove the boom and pivot bracket assembly
from the center frame to access the nylon
bushings.
5. Remove and inspect the nylon bushings from
the front and back sides of the pivot bracket
(Figure 73). Replace any damaged bushings.
6. Place a small amount of oil on the nylon
bushings and install them into pivot bracket.
7. Install the boom and pivot bracket assembly
into the center frame, aligning the openings
(Figure 73).
8. Install the pivot pin and secure it with the bolt
and nut removed previously.
Repeat the procedure for each boom.

Cleaning

Cleaning the Flowmeter

Occasionally, the flowmeter may need to be
cleaned to remove an obstruction.
Note: Make sure the pump is off when
performing this procedure.
1. Disconnect the flowmeter wire from wiring
harness.
2. Remove the retaining cap from the flowmeter
body (Figure 74).
4. Nylon bushing
5. Pivot bracket
Figure 74
1. Retaining cap
2. Paddle wheel assembly
3. Carefully pull the paddle wheel assembly from
the body.
4. Use warm water, a soft-bristled brush, and
a mild detergent as necessary to clean the
flowmeter body and paddle wheel. Remove
any small metallic debris.
Important: Do not use solvents or fuel
to clean the flowmeter.
5. Install the paddle wheel assembly into the
flowmeter body.
Important: The paddle wheel assembly
will only fit into the body one way, in a
detent slot on the side of the body. Do not
force the paddle wheel assembly into the
body in any other orientation.
6. Install the retaining cap.
7. Connect the wire to the flowmeter.
Cleaning the Suction
Strainer
Clean the suction strainer daily. If you are using
wetable powders, clean it after every tank.
1. Remove the retainer from the red fitting
attached to the large hose on the top of the
tank.
59
3. Flowmeter body