Belt Maintenance; Servicing The Drive Belt; Adjusting The Steering Pump; Belt - Toro 41177 Multi-Pro 1250 Operator's Manual

Figure 64
1. Parking brake lever
2. Knob
2. Rotate the knob until a force of 35-45 lb is
required to actuate lever.
3. Tighten the set screw.

Belt Maintenance

Servicing the Drive Belt

Checking the Drive Belt
Check the condition of the drive belt after the first
day of operation and every 200 operating hours
thereafter.
1. Position the sprayer on a level surface, set
the parking brake, move the range selector to
the Neutral position, stop the pump, stop the
engine, and remove the ignition key.
2. Rotate and inspect the drive belt for excessive
wear or damage. Replace the belt if necessary.
3. Set screw
Figure 65
1. Drive belt
2. Primary clutch
Replacing the Drive Belt
1. Rotate and route the belt over the secondary
clutch (Figure 65).
2. Remove the belt from the primary clutch.
3. Place the new belt over the primary clutch.
4. Rotate and install it over the secondary clutch.
Adjusting the Steering
Pump Belt
Check the tension of the steering pump belt after
the first day of operation and every 100 operating
hours thereafter. The belt should flex 1/4 inch (5
mm) when 5 lb of force (22 N) is applied midway
on the top span.
1. Park the machine on a level surface, set the
parking brake, turn the ignition off, and
remove the key.
2. Loosen the steering pump mounting bolts
(Figure 66).
54
3. Secondary clutch