Changing The Transmission; Fluid; Replacing The Transmission Oil Filter - Toro 03540 Reelmaster 5200-D Operator's Manual

3. Loosen the inner locknut securing the eye bolt
to the spring anchor plate (Figure 62).
Figure 62
1. Spring anchor plate
2. Eye bolt
3. Inner locknut
4. Rotate the outer locknut clockwise until the
distance between the inside of the eye bolt
loop and the inside of the spring anchor plate
is shortened 1/8 inch, as shown in Figure 62.
Tighten the inner locknut.
5. Operate the machine and check the stopping
distance. Repeat procedure if required.
Note: Shortening the distance between the
inside of eye bolt loop and inside of the spring
anchor plate increases the pedal force on the
traction pedal. Therefore, do not over adjust.

Changing the Transmission

Fluid

Change the transmission fluid after every 800
hours of operation or annually, whichever occurs
first, in normal conditions.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brakes, and remove the key from the
ignition switch.
2. Clean the area around the suction line on the
bottom of the transmission (Figure 63) and
place a drain pan under the line.
4. Outer locknut
5. Shorten distance to
decrease time required
to stop machine.
Figure 63
1. Transmission suction line
3. Remove the line from the transmission
allowing the fluid to drain into the drain pan.
4. Install the suction line to the transmission.
5. Fill the transmission with oil; refer to Checking
the Transmission Fluid in Operation, page 26.
6. Before starting the engine, after changing the
transmission fluid, disconnect the run (ETR)
solenoid on the engine, and crank the engine
for 15 seconds. This allows the charge pump
to fill the transmission with fluid before you
start the engine.
Replacing the Transmission
Oil Filter
Replace the transmission filter initially after
the first 200 operating hours and every 800
operating hours or annually, whichever occurs
first, thereafter.
Only the Toro replacement filter (Part No.
110-4146) can be used in the hydraulic system.
Important: Use of any other filter may void
the warranty on some components.
1. Position the machine on a level surface, lower
the cutting units, stop the engine, engage the
parking brakes, and remove the key from the
ignition switch.
2. Clean the area around the filter mounting area
(Figure 63) and place drain pan under filter.
3. Remove the filter.
4. Lubricate the gasket on the new filter with
hydraulic oil.
50
2. Transmission oil lter