Mounting The Hood Latch; Units Only); Replacing The Panel Fasteners; (Ce Units Only) - Toro 03540 Reelmaster 5200-D Operator's Manual

Step
2

Mounting the Hood Latch

(CE Units Only)

Parts needed for this step:
1 Locking hood switch
1 Lock washer
1 Nut
2 Key
1 Hood latch bracket
2 Bolt (1/4 x 3/4 inch)
2 Flat washer (1/4 inch)
2 Locknut (1/4 inch)
Procedure
1. Remove the plug from the hole in the left front
corner of the hood (Figure 3).
Figure 3
1. Hood plug
2. Open the hood.
3. Mount the locking switch to the hood with
a lock washer and nut. Position the switch
with the latch toward the front of the machine
(Figure 4).
1. Locking switch
4. Loosely mount the latch bracket to the radiator
support with 2 bolts (1/4 x 3/4 inch), flat
washers, and locknuts (Figure 4).
5. Adjust the latch bracket, until it is aligned with
the switch latch, then tighten the bolts.
6. Rotate the latch to the locked and unlocked
positions with the key. Remove the key and
store it in a memorable place.
7. Close the hood.
Step
3
Replacing the Panel
Fasteners (CE Units Only)
Parts needed for this step:
1 Flange-head bolt (5/16 x 5/8 inch)
1
Flange-head bolt (5/16 x 3/4 inch)
Procedure
1. Remove the fasteners securing the left front
corner of the floor panel and the left end of
the access panel to the frame (Figure 5).
15
Figure 4
2. Latch bracket