Service Interval Chart; Lubrication; Greasing The Bearings And Bushings - Toro 03540 Reelmaster 5200-D Operator's Manual

Service Interval Chart

1. Read the Operator's Manual.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Lubrication

Greasing the Bearings and
Bushings
If you operate the machine under normal
conditions, lubricate all grease fittings for the
bearings and bushings after every 50 hours of
operation with No. 2 General Purpose Lithium
Base Grease. Lubricate bearings and bushings
immediately after every washing, regardless of
the interval listed.
The grease fitting locations and quantities are as
follows:
• 3 fittings on the engine drive shaft (Figure 42)
Figure 41
• 2 fittings on each cutting unit carrier frame and
pivot (10 total) (Figure 43)
42
Figure 42