Cutting Unit System Maintenance; Adjusting The Cutting Unit Lift; Rate - Toro 03540 Reelmaster 5200-D Operator's Manual

Figure 73
1. Test port #1
Cutting Unit System
Maintenance
Adjusting the Cutting Unit
Lift Rate
The cutting unit lift circuit is equipped with 3
adjustable valves used to ensure that the cutting
units do not raise too quickly and bang against
the lift stops. Adjust the cutting unit lift rate as
follows:
Adjusting the Center Cutting Unit
1. Locate the valve behind the access panel above
the operator's platform (Figure 74).
2. Test port #2
Figure 74
1. Center cutting unit adjustment valve
2. Loosen the setscrew on the valve and rotate
the valve approximately 1/2 turn clockwise.
3. Verify the lift rate adjustment by raising and
lowering the cutting unit several times. Adjust
as required.
4. After attaining the desired lift rate, tighten the
setscrew to lock the adjustment.
Adjusting the Outside Front Cutting
Units
1. Locate the valve on the flow divider (under the
foot rest) (Figure 75).
Figure 75
1. Outside front cutting units adjustment valve
56