Storage; Preparing The Traction Unit; Preparing The Engine - Toro 03540 Reelmaster 5200-D Operator's Manual

Storage

Preparing the Traction Unit

1. Thoroughly clean the traction unit, cutting
units, and engine.
2. Check the tire pressure. Inflate all traction unit
tires to 15 to 20 psi (103 to 138 kPa).
3. Check all fasteners for looseness and tighten
them as necessary.
4. Grease all grease fittings and pivot points.
Wipe up any excess lubricant.
5. Lightly sand and use touch-up paint on painted
areas that are scratched, chipped, or rusted.
Repair any dents in the metal body.
6. Service the battery and cables as follows:
A. Remove the battery terminals from the
battery posts.
B. Clean the battery, terminals, and posts with
a wire brush and baking soda solution.
C. Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro
Part No. 505-47) or petroleum jelly to
prevent corrosion.
D. Slowly recharge the battery every 60 days
for 24 hours to prevent lead sulfation of
the battery.

Preparing the Engine

1. Drain the engine oil from the oil pan and
replace the drain plug.
2. Remove and discard the oil filter. Install a new
oil filter.
3. Refill the oil pan with 4 quarts of motor oil.
4. Start the engine and run it at idle speed for
approximately two minutes.
5. Stop the engine.
6. Thoroughly drain all fuel from the fuel tank,
lines, and the fuel filter/water separator
assembly.
7. Flush the fuel tank with fresh, clean diesel fuel.
8. Secure all fuel system fittings.
9. Thoroughly clean and service the air cleaner
assembly.
10. Seal the air cleaner inlet and the exhaust outlet
with weatherproof tape.
11. Check the antifreeze protection and add as
needed for expected minimum temperature in
your area.
59