Servicing The Engine Oil And Filter; Adjusting The Throttle - Toro 03540 Reelmaster 5200-D Operator's Manual

Figure 51
1. Filter element
4. Inspect the new filter for shipping damage,
checking the sealing end of the filter and the
body.
Important: Do not use a damaged
element.
5. Insert the new filter by applying pressure to
the outer rim of the element to seat it in the
canister.
Important: Do not apply pressure to the
flexible center of the filter.
6. Clean the dirt ejection port located in the
removable cover. Remove the rubber outlet
valve from the cover, clean the cavity, and
replace the outlet valve.
7. Install the cover orienting the rubber outlet
valve in a downward position—between
approximately 5:00 to 7:00 when viewed from
the end.
8. Secure the cover latches.
9. Reset the indicator (Figure 50) if it is showing
red.
Servicing the Engine Oil and
Filter
Change the engine oil and filter initially after the
first 50 hours of operation and every 150 hours
thereafter.
1. Remove the drain plug (Figure 52) and let the
oil flow into a drain pan.
Figure 52
1. Engine oil drain plug
2. When the oil stops, install the drain plug.
3. Remove the oil filter (Figure 53).
Figure 53
1. Engine oil lter
4. Apply a light coat of clean oil to the new filter
seal.
5. Install the replacement oil filter to the filter
adapter. Turn the oil filter clockwise until the
rubber gasket contacts the filter adapter, then
tighten the filter an additional 1/2 turn.
Important: Do not over-tighten the filter.
6. Add oil to the crankcase; refer to Checking the
Engine Oil in Operation, page 26.

Adjusting the Throttle

1. Position the throttle lever forward so that it
stops against the seat base slot.
2. Loosen the throttle cable connector on the
lever arm at the injection pump.
45