Adjusting The Tire Pressure; Installing The Cutting Units - Toro 03540 Reelmaster 5200-D Operator's Manual

Figure 5
1. Floor panel
2. Replace the floor panel fastener with a
flange-head bolt (5/16 x 5/8 inch) supplied in
loose parts (Figure 5).
3. Replace the access panel fastener with a
flange-head bolt (5/16 x 3/4 inch) supplied in
loose parts (Figure 5).
Step
4

Adjusting the Tire Pressure

No Parts Required
Procedure
The tires are over-inflated for shipping. Therefore,
release some of the air to reduce the pressure.
Correct air pressure in the front and rear tires is 10
to 15 psi (69 to 103 kPa).
Important: Maintain even pressure in all
tires to ensure uniform contact with the turf.
2. Access panel
Step
5

Installing the Cutting Units

Parts needed for this step:
5 Cutting unit (sold separately)
Procedure
1. Remove the cutting units from the cartons.
Assemble and adjust the as described in the
cutting unit Operator's Manual.
2. If you will be using baskets on the cutting units,
use the chart below (Figure 6) to determine the
locations at which you need to mount basket
guides to the cutting unit carrier frames. If you
will not be using baskets, proceed to step 4.
Figure 6
3. Mount a basket guide (Figure 7) to the
appropriate side of each cutting unit carrier
frame (Figure 8) with a bolt (5/16 x 1-3/4
inches), flat washer, and lock washer or
fasteners previously removed, as shown in
Figure 7.
16