10. Maintenance
10. Maintenance
10.1 Cleaning the Fan and the Cover
Refer to the following procedures and check the fan when error code E005 is shown. If the
fan is covered with dirty particles, clean the fan as guided in this chapter. Turn off the AC
circuit breaker and the DC disconnect switch in the distribution box, then separate the
Photovoltaic MC4 connector from the connector located on the side of the 3.6 kWh All in
One.
Removal of the Photovoltaic MC4 Connector
Remove the side cover. Make sure not to remove the front case cover.
80
NOTICE
Qualified Person Only!
[Figure 10-1: PV MC4 connector]
Australia (Eng.) 05/2015. Rev1.1