Table of Contents
Advertisement
3. Package Removal and Inspection
3.1 Package Removal and Tray Assembly
3.1.1 Removing the Enclosure Package
As shown in the figure in this section, remove the package components from the enclosure
in the following order.
1.
Place the system on the installation location.
2.
Open the upper part of the battery case.
3.
Remove both sides of the cover in the front of the product.
Australia (Eng.) 05/2015. Rev1.1
CAUTION
Included in this box are a battery and printed circuit board, and the entire
weight amounts to 95 kg. Therefore, special care must be taken in handling.
Make sure to have at least two persons deliver and remove the package.
3. Package Removal and Inspection
9
Advertisement
Table of Contents
