7. Entering Initial Installation Information
7.3.2 Inserting Jumper Wire
7.3.3 LAN Cable Connection between PC and System
7.3.3.1 LAN Cable Type
UTP cable/category 5E
1:1 direct cable
7.3.4 SIM (System Install Manager) Connection
7.3.4.1 To enable direct communication between the computer and the All in One, change
the TCP/IP settings on the computer as shown below:
Set on your laptop
[Control Panel → Network and Sharing Center → Change adapter settings → Local
Area Connector → Properties → Internet Protocol Version 4 (TCP/Ipv4)]
52
[Figure 7-1: Jumper]
Australia (Eng.) 05/2015. Rev1.1