Inner Wiring Connection (Power And Signal Wire Connection For Bms) - Samsung ELSR362-00004 Installation Manual

5. Electrical Connections
5.5 Inner Wiring Connection (Power and Signal Wire
Connection for BMS)
1.
The [Figure 5-10] shows the lead of the battery tray. As shown in the figure, two short
lines and two long leads come out from the battery. Plug four cable lines on the Tray
BMS into the upper BMS socket. Plug the two long lines on to the right side of the BMS,
then plug the short two lines on to the left side of it.
2.
As described in Subsection 5.4, fix the battery on the 3.6 kWh All in One, then check the
signal line of the battery part on the opposite side. All of the cables can be stuffed in the
corner of the enclosure. They do not need to be bound with a cable tie. The two shorter
cables on the left can be stuffed near the tray BMS while the two longer cables on the
right can be stuffed in the right corner of the enclosure.
3.
Finally, connect the power cable line coming out from the battery with the battery
power terminal in the middle. Connect BATT-A and BATT-B.
30
[Figure 5-10: Battery to BMS Connection]
[Figure 5-11: Cable Stuff Method]
Australia (Eng.) 05/2015. Rev1.1