Table of Contents
Advertisement
5. Electrical Connections
The [Figure 5-23] shows the structure of the terminal block.
After that, tie the cable to the mount using the cable tie B (larger one which is included as an
accessory) to the tie mount. You should tight the tie such that there will not be any slip when
you pull the cable with the force of 100N. And the end of outer cable surface should be
within 10 mm below the end of protrusion.
[Figure 5-24: Power Cable connection to the terminal block]
Use the screw to close the side cover and conform to the torque value of 1.2~1.8 Nm.
40
[Figure 5-23: Terminal Block]
Australia (Eng.) 05/2015. Rev1.1
Advertisement
Table of Contents
