Table of Contents
Advertisement
5. Electrical Connections
The [Table 5-7] shows the lead wire standard for the PV. The thickness (6mm
wire is recommended for the 3.6 kWh All in One.
PE
PV (+), (-)
After opening the side cover, perform the PV and AC connection. (Refer to the contents
below). Disassemble the screw to open the side cover.
The Male product is connected to the lead wire coming from the distribution box in the PV
side, and the Female part is attached to the All in One system. The two products are properly
docked when connected together. After opening the side cover, perform the PV and AC
connection.
38
[Figure 5-19: PV connector (Female) and PV line (Male)]
Area
6mm
2
6mm
2
[Table 5-7: Wire Standard]
[Figure 5-20: Side cover opening]
Insulation
600V or more
700V or more
Australia (Eng.) 05/2015. Rev1.1
2
) of the lead
Color code
Green with yellow lines
Black
Advertisement
Table of Contents
