Appendix A Error Messages - Fujitsu ETERNUS DX80 S2 Cli User's Manual

Appendix A
Error Messages
This appendix explains error messages output by CLI. The following is a description of message number,
messages, and recommended action. Refer to
of this document) for a detailed explanation on CLI error messages.
Table A.1
Message
number
E0001
E0002
E0003
E0004
E0005
E0006
E0007
E0008
E0009
E0010
E0011
E0012
Error message list
Bad value.
The operand of the specified parameter is incorrect. Check the parameters identified in the details of this
message.
Value out of range.
The operand of the specified parameter is out of the correct range. Check the parameters identified in the
details of this message.
Too many parameters.
Too many parameters were specified. Check the parameters identified in the details of this message.
Missing parameter.
Too few parameters were specified. Check the parameters identified in the details of this message.
Incorrect parameter combination.
The combination of the parameters specified is incorrect. Check the parameters identified in the details of
this message.
Inconsistent status.
The status of the object specified is inappropriate for the operation requested. Check the status of the
object identified in the details of this message.
Inconsistent usage.
The usage requested is incorrect for the specified object. Check the permitted usage of the object
identified in the details of this message.
Inconsistent size.
The size requested does not correspond with the current size. Check the size of the object identified in the
details of this message.
Inconsistent RAID level.
The operation is not appropriate for the RAID level of the specified RAID group. Check the RAID level of the
group identified in the details of this message.
Inconsistent model type of device.
The specified operation is not appropriate for the type of device. Check the type of device identified in the
details of this message.
Inconsistent network setup.
This message indicates that the network settings are incorrect. Check the network settings by using the
"show network" command.
Inconsistent e-mail setup.
This message indicates that the e-mail settings are incorrect. Check the e-mail settings by using the
"show email-notification" command.
ETERNUS CLI User's Guide
"1.7 Error Message Format" (page 29)
Message
Countermeasure for the error
688
Copyright 2015 FUJITSU LIMITED
(in the overview section
P2X0-1030-09ENZ0