Fujitsu ETERNUS DX80 S2 Cli User's Manual page 374

Chapter 4 Function/System Settings and Display
4.1 User Management > set radius
-primary-port
-primary-port-number
-primary-authentication-mode
-primary-shared-secret
-primary-retry-timeout
-secondary-server
Optional. This parameter specifies the port number of the primary server for the authentication
protocol.
maintenance
MNT port
remote RMT port
Optional. This parameter specifies the UDP port number of the primary server for the
authentication protocol. Specify the port number within 1 to 5 digits. The port number cannot
be set above 65535. If omitted, the existing setting is not changed. The default value is 1812.
Optional. This parameter specifies the authentication method type of the primary server. If
omitted, the existing setting is not changed. The following methods can be specified:
chap Use CHAP. (Default)
pap Use PAP.
PAP: Password Authentication Protocol
Optional. This parameter specifies the shared secret of the primary server (up to 64
alphanumeric characters). If omitted, the existing setting is not changed.
Optional. This parameter specifies the retry timeout value of the primary server. If omitted, 30
seconds (default value) is used. The timeout value should be selected from following values:
10 10 seconds
20 20 seconds
30 30 seconds (Default value)
40 40 seconds
50 50 seconds
60 60 seconds
Optional. This parameter specifies the secondary server. Only one server can be specified. The
server name format should be IPv4 standard notation (a base 256 "d.d.d.d" string), IPv6
address format, or a fully qualified domain name (FQDN). The types of IPv6 addresses that can
be specified are global addresses (including 6to4 addresses), link local addresses, and unique
local addresses. Up to 64 alphanumeric characters can be specified.
Example: -secondary-server 192.168.1.20
Example: -secondary-server fd80::abd0:223:ad
Example: -secondary-server foo.bar
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
374
P2X0-1030-09ENZ0