Fault Rectifi Cation; Technical Data - Baratza Vario Operating Instructions Manual

a) Remove all beans from the hopper. Press the
START button to grind any beans remaining in
the grinder housing.
GEFAHR Disconnect the plug from the socket.
b) Remove the hopper by turning it anticlock-
wise as far as possible, and then lift it out of
the housing. Wash the hopper, the lid and the
ground coffee container in warm, soapy water.
c) Turn the upper grinding disc carrier (see illus-
tration above) clockwise as far as it will go and
lift it out of the housing.
d) Clean the grinder with a small brush. Remove
all coffee residues from the two grinding
discs. Ensure that no coffee residues remain
in the closure mechanism.
e) Replace the upper grinding disc carrier on the
grinder housing and turn it clockwise as far as
it will go.
f) To insert the hopper, follow the instructions
on 4.2.
11. FAULT RECTIFICATION
Observe the safety instructions given in
DANGER
Chapter 1 at all times!
PROBLEM
The coffee grinder fails
to start when it is swit-
ched on, although the
time continues to run:
The coffee - grinder
functions normally,
but stops abruptly:
TIP
Ensure that the hopper is
correctly inserted and tur-
ned clockwise as far as it will
go. The safety switch must
close correctly
Switch off the coffee grin-
der immediately. A foreign
body such as a small stone,
a green, unroasted coffee
bean or a twig may have
PROBLEM
The coffee grinder fails
to start after pressing
the Start button. The
motor hums.
The ground coffee is
not fi ne or coarse en-
ough.
Incorrect function of
display. Grinder can
still be started.
If you cannot correct the fault, contact your dealer
or Customer Service. Note the instruction in
Chapter 1 "Danger due to unauthorised repair".

12. TECHNICAL DATA

Description
Grinding disc
diameter
Voltage
Power consumption
Grinding
performance
Emission noise level
Hopper capacity
Net weight
D O M E S T I C C O F F E E G R I N D E R S
TIP
blocked the grinder. See
10.2.2 Manual cleaning of
the grinder.
There is a foreign body in the
grinder which is blocking the
grinding discs. Switch off the
coffee grinder immediately,
and follow the instructions
given under 10.2.2 Manual
cleaning of the grinder.
The motor has overheated
after being over-stressed.
Leave the grinder to cool
down (approx. 30 min.) be-
fore starting it again. If the
motor still fails to start, fol-
low the instructions given
under 10.2.2 Manual clea-
ning of the grinder.
Check the grind adjustment..
Unplug the grinder. After 5
seconds reconnect it to the
power supply.
VARIO Home domestic
coffee grinder
54 mm ceramic
200-240V or 100-120V
max. 2A
approx. 1.6 g/s at Espres-
so setting
70-75 dB when grinding
approx. 250 g
3.7 kg
11