Baratza Vario+ Quick Start Manual

®
Vario+
Thank you for choosing the
Baratza Vario+ for your home
grinding needs!
This is just a quick start guide. If you would like more detailed instructions,
please skip ahead to the full manual, found online at
baratza.com/documentation/
SETUP:
1.
Remove everything from the packaging and hand wash the lid (1),
hopper (2) and grounds bin
2.
Position the shut-off knob
downward force, and feel for the hopper to insert into place. Once
inserted, firmly rotate the hopper clockwise to center the shut-off
knob and lock the hopper into place.
3.
If using the grounds bin, remove the PortaHolder
firmly out, then insert the grounds bin.
If using the PortaHolder and you find it needs adjustment to fit your
portafilter: remove the PortaHolder, loosen screws on the back, adjust
the arms' position, then tighten screws gently.
4.
Plug in the grinder.
5.
Reference the Grind Settings Chart below and set the grind size.
When adjusting finer, the grinder must be running or completely
6.
empty of beans to prevent the adjustment system from binding on
beans that are between the burrs.
7.
Add beans to the hopper.
8.
Select grind time preset (9)
to grind.
9.
Presets 1, 2 and 3 set the grinder to run for a designated time and
can be adjusted with the up/down arrows
by pressing and holding that preset button. Manual (M) mode runs
the grinder until the Stop button is pressed or 90 seconds max.
PARTS IDENTIFICATION
Hopper lid
1.
Bean hopper
2.
Bean shut-off knob
3.
Grind time preset
4.
adjustment buttons
Micro adjustment lever knob
5.
Macro adjustment lever knob
6.
Start/Stop button
7.
QUICK START GUIDE
(13) with warm soapy water. Let air dry.
(3) near the rear left of the grinder, apply
(10) by pulling
or manual mode (8) then press start
(4) and saved to a preset
Manual mode button
8.
Grind time presets
9.
PortaHolder
10.
Burr calibration tool
11.
(see manual)
Burr removal tool
12.
(see manual)
Grounds bin
13.
4
5
7
9
10
5
7
(7)
1
2
9
13
Rev 1/5/2021 (v1.0)
EN
3
6
8
6
4
8
11
12