Buffalo TeraStation 1000 User Manual page 88

If you installed the TeraStation with the TeraNavigator CD, NAS Navigator2 was installed automatically. Click the
icon in the Dock to start NAS Navigator2.
Click on a TeraStation's icon to display:
• Total capacity
• Used capacity
• Workgroup
• IP address
• Subnet mask
• Default gateway
• MAC address
• Firmware version
Double-click it to open a share on the TeraStation.
Name
Open
Refresh
I'm here
*
Settings
Configure
Label Color
View Options
Auto Power Mode
To display these options,
hold down the control
key and click your
TeraStation's icon.
*"I'm here" is only available on TS1400D models. When clicked, the TeraStation will beep and its power LED will blink
red.
Open Folder
Settings
Configure
I'm here
*
Label Color
Description
Opens the default shared folder for a selected
TeraStation.
Searches for NAS devices on the network again.
Causes your TeraStation to beep.
Opens Settings for the selected TeraStation.
Opens a window that lets you change the NAS's IP
address or open Settings.
Selects the color of the name displayed below the icon.
Lets you choose icon size, position, and view mode.
Auto power mode can turn supported TeraStations and
LinkStations on the network on and off automatically.
Opens the TeraStation's shared folder.
Opens Settings for the selected TeraStation.
Opens a window that lets you configure NAS's IP address
or open Settings.
Causes your TeraStation to beep.
Selects the color of the name displayed below the icon.
87